Replacing The Gas Cylinder; Operation; Cleaning And Maintenance - Campingaz RBS ESTATE 4 Series Operation And Maintenance

GB
m) SIDE HOTPLATE GRILL
(depending on the model)
Your barbecue's side hotplate may be equipped with 2
types of grill: a flat or corrugated grill.
Install the one you want to use on your hotplate's
saucepan stand. Light the hotplate and take advantage
of an additional grill surface.
You can adjust the hotplate's temperature by adjusting
the flow to the hotplate burner by setting the control
knob to ( ) or (
n)

REPLACING THE GAS CYLINDER

always work in a well ventilated area and never in the
presence of a flame, spark or heat source.
return the control knobs in the "off" position (O) then
close the cylinder valve.
remove the regulator, check that the sealing joint is in
good condition.
put the full cylinder in place, refit the regulator, taking
care not to apply stress to the hose. Check for gas
leaks.
o) OPERATION
It's recommended that protective gloves be worn to
handle components which may be very hot.
On first use, heat the barbecue with the hood closed and
burners in the high position (
in order to get rid of the paint smell on new parts.
In normal operation, preheat the barbecue with the lid
closed for 15 to 20 minutes to bring the cooking grids up
to the correct temperature.
In order to reduce food from sticking to the grilles, brush
the grilles lightly with cooking oil prior to placing any food
to be grilled.
In order to reduce the amount of grease catching fire
while cooking, remove any surplus fat from the meet
prior to placing it on the grille. Clean the barbecue after
each use to prevent the accumulation of grease and the
risk of it catching fire.
Should a burner go out while the appliance is operating,
the gas supply is automatically cut by the STOPGAZ
system. Reset the control button to the "OFF" position
(O) and repeat the ignition procedure.
p) CLEANING AND MAINTENANCE
Never modify the barbecue: any modification may
prove dangerous.
After each use, remove the parts from the bottom of the
bowl (reflector, grease tray) and clean them using a
sponge and washing up liquid. They can also be put in
the dish washer.
In order to maintain your barbecue in perfect operating
condition, it is recommended to clean it periodically
(after 1 or 2 uses).
wait until the barbecue has cooled down before
cleaning. close the gas cylinder.
If the appliance has not been used for 30 days, also
check that the burner orifices have not been blocked by
spiders webs as this could lead to a decrease in the
).
) for around 30 minutes
barbecue's efficiency or a dangerous ignition of gas
outside the burner. Clean the holes in the venturi tube
(see figure below) or the burner, as appropriate.
Venturi tube openings
Hearth walls, shelves, lower front strip, side and
rear panels, doors, side baskets
clean these elements from time to time using a sponge
with washing up liquid. do not use abrasive products.
H Grid and hotplate stand
To make cleaning this stand easier, Campingaz® has
invented Campingaz
Campingaz Instaclean
be dismantled without the need for tools in less than a
minute and can be cleaned in a dish washer.
Depending on how dirty these parts are, you may need
to brush them before putting them in the dish washer
for a more thorough clean. For assembly and
disassembly of these parts, please refer to the
assembly manual.
H Hotplate and cooking grid.
Your hotplate and cooking grid are enamelled.
Wait for them to cool before attempting to clean them.
Use Campingaz® BBQ Cleaner Spray and barbecue
brushes for cleaning.
You can clean your hotplate and cooking grid in the
dish washer. It is often necessary to supplement this
cleaning by rubbing with a sponge or wire brush.
To remove the
hotplate, slide your finger into
the hole shown below. Lift the
hotplate and take hold of it with
your other hand.
To remove the two part,
cast iron grid
paragraph t) Accessories),
first remove the
portion using the tab as
shown below, then remove
the edge.
H Grease tray
Your barbecue is fitted with two grease recovery trays.
We recommend cleaning them after each use. They
can be cleaned in a dish washer.
To make cleaning easier, the width of the grease trays
is sized so that you can cover them with a sheet of
aluminium foil available from the shops before
switching the barbecue on. After using the barbecue,
throw the sheet of aluminium foil away.
You can also put some sand into the bottom of the
grease tray to absorb the cooking fat. Throw the sand
away each time the barbecue is used.
Heat reflector (WHshaped part)
You can clean this part in a dish washer. It is often
necessary to supplement this cleaning by rubbing with
a sponge or flexible brush.
12
Burner
TM
Instaclean . Thanks
TM
, the 6 parts of the stand can
cast iron
(see
central
to