Checking For Gas Leaks; Prior To Use - Campingaz RBS ESTATE 4 Series Operation And Maintenance

GB
a 14 mm spanner to immobilise the appliance's
inlet connector.
an adjustable spanner to tighten the nut on the
flexible pipe.
use a spanner to tighten the nut on the flexible pipe on
the regulator.
check for leaks following the instructions in paragraph
f).
Check that the flexible hose stretches out normally
without twisting or pulling and does not come into
contact with the hot sides of the barbecue. It should be
replaced when the expiry date on the hose is passed or
whenever it is damaged or develops surface cracks.
Do not pull or pierce the hose. Keep away from any
parts of the barbecue that get hot.
Belgium, Luxembourg, United Kingdom, Ireland,
Portugal, Spain, Italy, Croatia, Greece, Netherlands,
Czech Republic,
Norway, Sweden,
Turkey, Romania, Poland:
The barbecue is equipped with a circular connector. It
should be used with flexible hose that is suitable for use
with butane and propane gas.
Hose length should not exceed 1.20 meters. It should be
replaced if it is damaged or develops surface cracks or
when so required by national legislation.
Do not pull or pierce the hose. Keep away from any
parts of the barbecue that get hot.
Check that the flexible hose stretches out normally,
without twisting or pulling.
Switzerland, Germany, Austria:
The barbecue should be used with flexible tubing that is
suitable for use with butane and propane gas.
Tubing length should not exceed 1.50 meters. It should
be replaced if it is damaged or develops surface cracks
or when so required by national legislation. Do not pull
or pierce the tubing.
Keep away from any parts of the barbecue that get hot.
Check that the flexible hose stretches out normally,
without twisting or pulling.
Flexible tubing connection: to connect the tubing to the
connector on the barbecue, tighten the nut on the tubing
firmly but without excess force using the two wrenches
provided:
no. 14 wrench to tighten the connector
no. 17 wrench to tighten the nut on the tubing
Slovakia, Hungary, Slovenia,
Denmark, Finland, Bulgaria,
e) LID
Handle the lid carefully, especially during operation. do
not lean over the base.
f) CHECKING FOR GAS LEAKS
1) Work outside, away from all sources of ignition. do
not smoke.
2) Make sure the control knobs are in the "off" (O)
position.
3) Connect the flexible tubing to the connector and
barbecue as described in part d).
4) Fit the regulator onto the gas cylinder in accordance
with its instructions.
5) Use a gas leak solution to test for leaks. Important:
never use a naked flame to check for gas leaks.
6) apply the solution
cylinder/regulator/ hose/apparatus (the control knobs
should remain closed: « OFF » position (O)). Open
the gas cylinder valve.
7) bubbles in the gas leak solution indicate that there
are gas leaks.
8) The leak can be stopped by tightening any hose
connection or replacing any faulty component. the
barbecue must not be used until the leak is stopped.
9) Close the valve on the gas cylinder.
Important:
Never use a naked flame to check for gas leaks.
Check for leaks at least once per year and each time the
gas cylinder is replaced.
g) PRIOR TO USE
Never use the barbecue until the instructions have been
read carefully and understood. also, make certain that:
there are no leaks
the venturi tubes are not blocked (example: spider
webs).
Venturi tube openings
the hose does not touch any components which may
get hot.
10
to the connections