Operation And Maintenance; For Your Safety; Element Assembly; Gas Cylinder - Campingaz Plancha EX Plus Manual

NOTE: Unless otherwise specified, following generic terms "appliance / unit / product / equipment /
device" appeared in this instruction manual all refer to the product "Plancha EX Plus / Plancha EXB Plus /
Plancha EX Extra".
• Please read the instructions carefully before using.
• Use outdoors only
• It is best to wear gloves to assemble the product.
• Do not use charcoal.
• Do not use an adjustable low pressure regulator. Use fixed regulators that comply with the European
standard concerning them.
• Regularly clean the parts at the frame bottom to avoid risk of inflammation from fat drippings.
Follow these instructions carefully to avoid seriously damaging your barbecue.
a) FOR YOUR SAFETY
- Do not store or use petrol and other flammable liquids
or vapours in the vicinity of this appliance. This device
must be kept away from inflammable materials when it
is in use.
If you smell gas:
1) Close the valve of the cylinder
2) Extinguish all naked flames
3) If the smell continues ,see "f Checking for gas leaks"
or immediately seek advice from your local retailer.
- Parts which are protected by the manufacturer or the
manufacturer's representative must not be manipulated
by the user.
- Do not leave your appliance unattended while it is
working.
- Close the gas container after use.
b) LOCATION
- This appliance must only be used outdoors.
- CAUTION: accessible parts may get very hot. Keep
young children away.
- There should be no combustible materials within a
radius of approximately 1 m around the appliance
- Do not move the appliance when the burners are
operating.
- Place your device and the gas cylinder on a flat, stable
and non-inflammable surface. If you use your device on
grass, make sure that the grass is not too high and that
it is not in contact with the burner flame to avoid the risk
of fire.
- Use the unit on horizontal ground.
- The gas tank has to be placed at least 12 in. (30 cm)
away from the unit.
- Estimated air offtake 2 m
c) ELEMENT ASSEMBLY
model)
- Install the grease container on the front side of the
appliance (fig.1 page 4).
- Place the cooking griddle on the fold of the windshield
as indicated.
■
Model with cast iron griddle: fig.2-a
■
Model with steel griddle: fig.2-b. Make sure the tabs of
the griddle are aligned with the windshield.
d) GAS CYLINDER
This appliance has been adjusted to operate off 5 to 15
kg butane/propane cylinders with an appropriate low
pressure regulator:
■
France, Belgium, Luxembourg, United Kingdom,
Ireland, Portugal, Spain, Italy, Greece :
butane 28 mbar / propane 37 mbar.
■
Netherlands, Czech Republic, Slovakia, Hungary,
Slovenia, Norway, Sweden, Denmark, Finland,
Bulgaria, Turkey, Romania, Estonia, Croatia,
Switzerland: butane 30 mbar / propane 30 mbar
■
Poland: propane 37 mbar.

Operation and maintenance

/kW/h.
3
(depending on the
Always connect or replace the cylinder in a well-ventilated
area, never in the presence of a flame, spark or heat
source.
The height H of the cylinder must be less than 27.5 in.
(70 cm), regardless of the cylinder's width or diameter D.
e) HOSE
■
France (depending on model)
The equipment may be used with two types of
flexible hose:
a) flexible hose designed to be joined onto ringed
tailpieces on both the appliance and regulator sides,
held firm with collars (in accordance with standard XP
D 36-110). Recommended length 1.25 metre.
G 1/2
Barbecue
b) flexible hose (according to standard XP D
36-112) fitted with a G 1/2 threaded nut for fixing to
the appliance and a M 20x1.5 threaded nut for fixing
to the regulator, recommended length 1.25 metre.
G 1/2
Barbecue
The appliance has a G1/2 threaded gas inlet connector.
Depending on model it can be supplied with a pre-
fitted NF ringed hose connector and seal.
1) To use the equipment with the flexible hose XP
D 36-110: (section e) a))
- slide the flexible hose onto the ringed tailpiece on
both the appliance and regulator as far as it will go.
9
H
D
GB
M 20x1,5
Regulator
M 20x1,5
Regulator
Black