WilTec 61935 Operation Manual page 8

SAFETY INSTRUCTIONS TABLE SAW
Operation is only permitted with a residual current circuit breaker (RCD max. residual current
30 mA).
Wear hearing protection. Noise exposure can cause hearing loss.

Gloves must be worn when handling saw blades and rough materials.

Dust generated during work is often harmful to health and should not get into the body. Use a dust

extractor and wear a suitable dust mask. Thoroughly remove deposited dust.
Before each use, check the device, connection cable, extension cable and plug for damage and

aging. Have damaged parts repaired by a specialist before using them again.
NEVER use the device without the protective device of the machine.

For safe working use devices such as protective and pressure equipment, stop plate, feed slide

etc.!
Faults in the machine, including the protective device or the saw blades, must be reported as soon

as they are detected and rectified immediately.
Circular saws must not be used for slitting, e.g. to finish a groove in the workpiece.

Folding or grooving is only permitted with a suitable protective device, e.g. a tunnel protective de -

vice above the sawing table.
Support large panels to reduce the risk of kickback from a jamming saw blade. Large panels can

bend under their own weight. Panels must be supported on both sides, both near the saw gap and
at the edge.
Do not remove chips or splinters while the machine is running.

Worn table liners must be replaced in good time.

Do not use saw blades that are damaged or deformed.

The base body of the saw blade must not be thicker and the set must not be smaller than the

thickness of the riving knife. The riving knife must not be removed.
Always select a saw blade suitable for the material to be cut.

Saw blades that do not correspond to the characteristics in these instructions for use must not be

used.
Do not use tools that comply with EN 847-1.

Saw blades made of high-speed steel must not be used.

The tools must be transported and stored in a suitable container.

The maximum speed indicated on the saw blade must be maintained.

The circular table saw may only be transported with the transport lock on the handle engaged.

The upper protective hood must not be used as a handle for transportation.

During transport of the machine, the upper protective hood must cover the upper part of the saw.

To minimize noise, the tool must be sharpened and all noise reduction elements (covers, etc.)

must be properly adjusted.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Seite 28