Downflow To Horizontal; Attaching Exhaust And Combustion Air; Inlet Hoods - Daikin Maverick I Installation And Maintenance Manual

Downflow to Horizontal

1. Remove the screws and covers from the outside of the
supply and return sections. Also remove and discard the
cover plate.
2. Install the covers over the bottom supply and return
openings, painted side up, inserting the leading flange
under the bracket provided. Place the back flange to top
of the front bracket provided. See
3. Secure the return and supply cover to front bracket with
two (2) screws.
Figure 2: Horizontal Conversion Detail
Step 1
Step 2
Figure 3: Clearances
RECOMMENDED
CLEARANCE
18/42"
18/48"
* WITHOUT ECONOMIZER/48" WITH
ECONOMIZER
IM 972-2 • MAVERICK I ROOFTOP SYSTEMS
Figure 2 and Figure
LOCATION
A – FRONT
80"
B – CONDENSER COIL
18"
+ C – DUCT SIDE
*D – EVAPORATOR END
E – ABOVE
60"
C
*D

Attaching Exhaust and Combustion Air

Inlet Hoods

Do not operate this unit without the exhaust/ combustion air inlet hood
properly installed.
The hood ships in a carton in the blower compartment inside
3.
the unit and must be attached when the unit is installed.
To attach exhaust/combustion air inlet hood:
1. Remove screws securing blower access panel and
remove access panel. For location of blower access
panel.
2. Remove exhaust/combustion air inlet hood from the
carton, located inside the blower compartment.
3. Attach blower access panel.
4. Attach the combustion air inlet/exhaust hood with
screws. Screws are in carton with the hood.
5. Vent the unit using the flue exhaust hood, as supplied
from the factory, without alteration or addition. The only
exception is with factory approved additions.
+ WITHOUT HORIZONTAL ECONOMIZER/ 42" WITH
HORIZONTAL ECONOMIZER
E
VERTICAL
CLEARANCE
6
Mechanical Installation
IMPORTANT
B
A
www.DaikinApplied.com