Legal Information; Fcc Operation Specifications - CaptionCall 78T User Manual

Legal information

FCC operation specifications

The CaptionCall phone complies with Part
15 of the FCC rules. Operation is subject to
the following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation. Any changes or
modifications not expressly approved by the
manufacturer could void the user's authority
to operate the equipment.
IMPORTANT! Any changes or modifications
not expressly approved by the party
responsible for compliance could void the
user's authority to operate this equipment.
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there
is no guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can
be determined by turning the equipment
off and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
This equipment complies with Part 68
of the FCC rules and the requirements
adopted by the ACTA. On the base of this
equipment is a label that contains, among
other information, a product identifier in the
format US:AAAEQ##TXXXX. If requested, this
number must be provided to the telephone
company.
This telephone connects to the telephone
network using an RJ11 connector. A plug and
jack used to connect this equipment to the
premises wiring and telephone network must
comply with the applicable FCC Part 68 rules
and requirements adopted by the ACTA. A
compliant telephone cord and modular plug
is provided with this product. It is designed
to be connected to a compatible modular
jack that is also compliant. See installation
instructions for details.
The REN is used to determine the number
of devices that may be connected to
a telephone line. Excessive RENs on a
telephone line may result in the devices
not ringing in response to an incoming
call. In most but not all areas, the sum of
RENs should not exceed five (5.0). To be
certain of the number of devices that may
be connected to a line, as determined by
47