Table of Contents
Advertisement
1.3.4 Linux
It can be available on Linux 2.4 higher.
[Automatic Mount]
After booting, do log-in.
Connect MG-350SHD -> Power On MG-350SHD -> Check the detection with [fdisk] -> make Mount Pointer (ex. mediatest) at
Folder Mount(/mnt) -> Edit [/etc/fstab] -> add the following;
/dev/sda /mnt/mediatest vfat noauto, user 0 0
/dev/sda /mnt/mediatest ntfs noauto, user 0 0
Do Log-in again.
above example "sda" is assumed that the MG-350SHD will be detected as "sda" on your system. If not, you have to write the drive name which
is detected as "USB Mass Storage", not "sda"
[Manual Mount]
Connect MG-350SHD -> Power On MG-350SHD -> Check the detection with [fdisk] -> make Mount Pointer (ex. mediatest) at
Folder Mount(/mnt) -> Edit [/etc/fstab] -> add the following;
mount –t vfat /dev/sda /mnt/mediatest (in case of FAT32 HDD)
mount –t ntfs /dev/sda /mnt/mediatest (in case of FAT32 HDD)
above example "sda" is assumed that the MG-350SHD will be detected as "sda" on your system. If not, you have to write the drive name which
is detected as "USB Mass Storage", not "sda"
[How to stop using]
Do [unmount] at Device Control.
1.3.5 Mac
It can be available on Mac 9.0 higher.
No need to install the installation driver at Mac OS 9.x version and the MG-350SHD will be detected automatically. If the MG-
350SHD is detected correctly, an icon is appeared at a monitor.
When removing MG-350SHD safely, drag the icon to a trash and unplug MG-350SHD.
(in case of FAT32 HDD)
(in case of NTFS HDD)
21
Advertisement
Table of Contents
