Removing Electronic Control - KitchenAid KMTM704E Series Technical Education

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or
electrical shock.
Removing the Electronic Control
The electronic control is located under the tub between the
float switch and terminal box (see Figure 1).
Float Switch
Electronic
Control
Terminal Box
1. Unplug dishwasher or disconnect power.
2. Remove the ground wire clip from control mount bracket,
(see Figure 2).
3. Slide electronic control to the left to disengage tabs from
control bracket, (see Figure 3). Remove control assembly.
NOTE: Terminal box removed to show control tab locations.

Removing Electronic Control

Figure 1
Ground
Wire Clip
Figure 2
4. Remove covers to access electronic control assembly, (see
Figures 4 & 5).
NOTE: The wiring harness provides enough length to access and
test the control from the front of the dishwasher. See Figure 6.
KitchenAid 2015 Microfiltration Dishwashers
COMPONENT ACCESS
Control
Tabs
Figure 3
Figure 4
Figure 5
Figure 6
4-19
n