Control Guide - KitchenAid KDTF324PPA Options Manual

Control Guide

Control: Purpose:
Start To start or resume a wash
Resume cycle.
Cancel To reset any cycle or
Drain options during selection, to
cancel a wash cycle after it
has started, or to drain out
any visible water in the tub
after a cycle has finished.
Clean To indicate completion of
your dishwasher cycle.
NOTE: Indicators shown are
not available on all models.
Sanitized Shows that the items have
been sanitized.
Descale If limescale accumulation is
detected, the descale icon
will show. Salt may need
to be added to the reservoir
and the water hardness
level set.
Use a dishwasher cleaning
agent such as affresh
the Tough cycle to clean the
dishwasher.
Time on the The remaining time left in
Floor the cycle will be displayed
on the floor.
Salt If the consumer desires to
Indicator use the water softener
feature in the dishwasher,
the salt indicator light will
glow when it is time to add
more salt.
Rinse Aid
Icon will turn on when
dishwasher is low on rinse
aid.
Comments:
If the door is opened during a cycle or the power is interrupted, the Start indicator
flashes. The cycle will not resume until the door is closed and Start is selected.
NOTE: If the Start button is located on top of door, push door firmly closed within
4 seconds of selecting Start. If the door is not closed within 4 seconds, the Start
button LED will flash, an audible tone will be heard (on some models), and the cycle
will not start.
Press Cancel/Drain and close door firmly. The dishwasher starts a drain sequence. Let
dishwasher drain completely.
The dishwasher will turn off once the cycle is complete. If this option is not available, the
clean indicator will glow when the cycle is finished. If the Door Open Dry system is
available, the door will open when the cycle is complete. The clean indicator will glow
when the cycle is finished.
The Sanitized indicator glows when the items have completed the Sanitize cycle. The
sanitized indicator blinks if Sanitization failed.
Once completed, the icon will turn off.
NOTE: In cases of extremely high amounts of limescale, descaling may have to be
performed twice.
®
with
The cycle time will be displayed underneath the unit on the floor once you select a cycle
and close the door. As the cycle progresses, the remaining cycle time will adjust.
Refer to the owners manual for more details about how to use the water softener feature.
If used, the salt indicator
If icon is on, add rinse aid until icon turns off.
will glow when you need to add more salt.
3