Honeywell LMB HYPER 120-03 Component Maintenance Manual With Illustrated Parts List page 101

(m)
(n)
(o)
(p)
WARNING: THE OVEN IS AT HIGH TEMPERATURE. WEAR PROTECTION GLOVES TO
(q)
The document reference is online, please check the correspondence between the online documentation and the printed version.
COMPONENT MAINTENANCE MANUAL
1 Put the filter board (01-170A) in position on the equipped housing (01-640).
NOTE: Install the power cables and the wires through their dedicated hole of the
filter board (01-170A). Let a sufficient length of the heat shrinkable conduits
(01-760) above the board so that they protect the wires through the ferrites.
2 Apply a layer of adhesive material (M38B) on the thread of four screws (01-180) and
one screw (01-200).
3 Attach the filter board (01-170A) to the equipped housing (01-670) with six screws
(01-180), eight washers (01-190) and two screws (01-200).
4 Torque the screws (01-180) and (01-200) to the specified value (Ref. TASK
21-22-91-820-802-A01).
For PNR 00001059 Amdt C
1 Put the filter board (01-170B) in position on the equipped housing (01-640).
NOTE: Install the power cables and the wires through their dedicated hole of the
filter board (01-170B). Let a sufficient length of the heat shrinkable conduits
(01-760) above the board so that they protect the wires through the ferrites.
2 Apply a layer of adhesive material (M38B) on the thread of four screws (01-180) and
one screw (01-200).
3 Attach the filter board (01-170B) to the equipped housing (01-670) with six screws
(01-180), eight washers (01-190) and two screws (01-200).
4 Torque the screws (01-180) and (01-200) to the specified value (Ref. TASK
21-22-91-820-802-A01).
Solder the power cables on the board with solder material (M60X) and a soldering
iron at 430 °C (806 °F) (Ref. Fig. 7006).
NOTE: If the cables are new, cut them at 110 mm (4.33 in) from the board and strip
them on 5 mm (0.197 in).
Solder the wires on the board with solder material (M60X) and a soldering iron at
350 °C (662 °F) (Ref. Fig. 7006).
NOTE: If the wires are new, cut them at 70 mm (2.76 in) from the board and strip
them on 5 mm (0.197 in).
Clean the solders and apply a layer of varnish SCC3 (MXXD).
PREVENT INJURIES.
Put the assembly in an oven at 90 °C (194 °F) for 24 hours.
00001059
21-20-99
Page 7015
Dec 15/06