3Com NBX 100 Installation Manual page 98

98 C 2: I
HAPTER NSTALLING
: Ce é.
: Ce é.
S H C
YSTEM ARDWARE OMPONENTS
See the appropriate page for instructions on how to install an optional
second disk when you are setting up your NBX system:
See the next topic,
install second disk on a V5000 system.
See "V3001R Disk Mirroring"
install second disk on a V3001R system.
V5000 Disk Mirroring
To install an additional disk drive for disk mirroring on a V5000:
1 Install the key code for your disk mirroring license, Licensing and
Upgrades > Licenses.
2 Shut down system software, System Maintenance > Reboot / Shutdown.
3 Turn off power to your system. If your NBX system has redundant power
supplies, disconnect both supplies.
WARNING: This device has more than one power input. Disconnect all
power inputs to power off this device.
AVERTISSEMENT: Ce périphérique comporte plusieurs entrées
d´alimentation. Déconnectez toutes les entrées d´alimentation afin de le
mettre hors tension.
VORSICHT: Dieses Gerät besitzt mehrere Eingänge zur Stromversorgung.
Trennen Sie das Gerät zum Ausschalten von allen Stromquellen.
4 Remove the disk drive tray. The tray is equipped with a lock so you might
need to unlock the tray. Unscrew the two knurl nuts on either side of the
disk tray and then pull the tray forward.
5 Unpack the second disk drive and install it in the open slot of the disk
tray.
6 Connect the ribbon cable and power connector correctly.
7 Re-insert the disk drive tray and tighten the locking nuts.
8 Connect power to the system.
Disk synchronization begins automatically and finishes in approximately
60 to 90 minutes, depending on the amount of information on disk 1
that must be mirrored on disk 2.
The status lights on the front of the V5000 indicate disk status. For
detailed information, see
"V5000 Disk Mirroring"
on page 99
"V5000 System Status LEDs"
for procedures on how to
for procedures on how to
on page 29.