Table of Contents
Advertisement
In the simple menus, the outer knob rotates through the available simple menu item or items that have
been previously configured by the user. See configuration section.
3.4
Menu Navigation
Menu navigation is guided by the second line of the display which will identify the menu group, menu
item, or parameter to be selected or changed. The active field will be backlit on the display line.
There are two sets of menus available in the DLC50: the Expert Menu, and the Simple User Interface
(Simple UI). Each is explained below. The Simple UI is a significantly reduced subset of the menu
system, is user configurable, and is trimmed down to just a few common functions and sub-menus that
the user will want or need to access during operation. The Simple UI allows easy access to common
functions without the need to navigate unnecessary menus. For example, the Simple UI could be
configured to enable only the TX channel selection and Encryption sub-menus. In this case, rotating
the outer knob will advance from normal display, to TX channel selection, to Encryption, and back to
normal display. The navigation keys also appear while the Simple UI is activated. Accepting a selection
or pressing cancel or exit will return to normal display. The Simple UI is set up under
Configuration>Simple UI from the Expert Menu.
To switch between Simple UI and Expert Menus, turn off the DLC50, then hold the 1 and 3 soft-keys in
while turning the DLC50 back on. Release the soft-keys after the splash-screen appears.
The Expert Menu system is the complete menu system that allows selection of all parameters and
functions controllable in the DLC50 and the attached microwave equipment as well as system
configuration functions. Using the rotary encoder, the user may navigate the Expert Menu system by
first selecting a menu group with the outer rotary knob, then the menu item with the inner rotary knob.
Pressing OK or the inner rotary knob will enter the selected submenu. There are 5 menu groups: DLC
Presets, TX, RX, Other, and Configuration. A listing of the 5 menu groups and their associated menus
is presented below.
Menu groups (and associated menus):
DLC presets
TX
RX
Other
Configuration
Notes:
The document reference is online, please check the correspondence between the online documentation and the printed version.
DLC50 Control Panel Installation and Operation Manual | Doc. No. 6051439500 Rev. A
Recall, Erase, Save. Allows management of DLC50 Presets which may be
configured to include TX and RX presets, channels, frequencies, and
encryption/decryption states, as well as relay states. (See Configuration>Presets
Setup)
Frequency, Channel, Power, Recall Preset, Encryption. Menus for controlling
transmitter related functions. Menu group will not appear if no transmitter
configured.
Frequency, Channel, Recall Preset, Decryption, Meter type. Menus for
controlling receiver related functions. Menu group will not appear if no receiver
configured.
Relay Control, Dim Control. Menus for controlling miscellaneous DLC50
functions.
Language, RX serial, TX serial, Remote serial setup, USB Flash functions,
External Relay Setup, Presets setup, Simple UI setup, Soft-key setup, key-timer
setup, system. Menus for configuring DLC50 and its connected microwave
system components.
The TX group will not appear if there is no transmitter configured.
The RX group will not appear if there is no receiver configured.
Additional menu items that are unique to a specific transmitter or receiver will
also appear in the appropriate TX or RX menu group when properly configured.
For complete menu group, menu, and sub-menu listing, see Appendix.
Broadcast Microwave Services
16
Hide quick links:
Advertisement
Table of Contents
