3Com CoreBuilder 2500 Getting Started Manual page 23

Installing the CoreBuilder System in a Distribution Rack 2-5
Tighten the mounting screws. The system is now
3
installed in the distribution rack.
Figure 2-5 shows two CoreBuilder 2500 systems
installed in a distribution rack.
You are now ready to install the Ethernet, Fast
Ethernet, FDDI, or ATM modules into the system.
For installation instructions, see Chapter 3: Installing
Modules or the media-specific module installation
guide for the module you are installing.
™
Figure 2-5 Two CoreBuilder 2500 Systems Installed in a
Distribution Rack