Installing The System; Before You Begin - 3Com CoreBuilder 2500 Getting Started Manual

I
NSTALLING THE
2
This chapter describes how to install your
™
CoreBuilder 2500 system on a table top, in a
free-standing stack, or in a distribution rack.
To install the CoreBuilder system on a table top
or in a free-standing stack, read these
instructions:
"Before You Begin" (the next section)
"Installing the CoreBuilder System on a Table
Top or in a Free-Standing
To install the CoreBuilder system in a distribution
rack, read these sections:
"Before You Begin" (the next section)
"Installing the CoreBuilder System in a
Distribution Rack" on page 2-2
S
YSTEM
Stack"

Before You Begin

Before beginning the installation procedures, be sure
to:
Read the appropriate configuration information in
Chapter 4: Cabling.
Move the CoreBuilder system close to where you
plan to install it.
Have a No. 2 Phillips screwdriver available.
Have the hardware kit readily available. See
Table 2-1.
Table 2-1 CoreBuilder
Item
10/32 x 1/2 Phillips
screws
"G" clips
M4 x 8 Phillips screws
M4 x 8 flathead screws 4
Rubber feet (self
adhesive)
™
System Hardware Kit
Qty To use in...
4 Installing the distribution
rack
4 Installing the distribution
rack
4 Distribution rack mounting
brackets (L-shaped)
Distribution rack mounting
brackets (U-shaped)
4 Table top or free-standing
stack installation