DMP Electronics 1140 Series Installation Manual

Description

The 1140 Series offer a Four-Button, Two-Button, or One-Button Keyfob transmitter that is portable, water resistant,
and designed to be clipped to a keychain or lanyard. The 1140 Series keyfobs provide operation within a maximum
of 200 feet of the receiver location. The 1140 Series keyfob LED provides visual acknowledgement when a button
is pressed and responds to each separate operation with specific color-coded LED displays. The 1140 Series keyfobs
operate using the supplied 3.0V universal Lithium coin cell battery.

What is Included

The 1140 Series Keyfob includes the following items:
• One 1145 Four-Button Keyfob Transmitter OR
One 1146 Two-Button Keyfob Transmitter OR
One 1147 One-Button Keyfob Transmitter
• One 3V Lithium CR2032 coin cell battery
• Peel-off Button ID Labels
• LED operation pocket card
• Serial number label

Transmitter Serial Number

For your convenience, an additional pre-printed serial
number label is included. Prior to installing the device,
record the serial number or place the pre-printed serial
number label on the panel programming sheet. This number
is required during programming.

Programming the Keyfob in the Panel

Refer to the XRSuper6/XR20/XR40 Programming Guide
(LT-0305) as needed. Program and assign an address to the
1140 Series Keyfob in Wireless Devices during panel programming. As soon as the 1140 Series keyfob is programmed,
Optional
Small or
Large
Labels are
available.
Figure 2: Button Labels
INST ALLA TION GUIDE
1140 Series Keyfob Transmitters
the default button operation is activated. See Figure 1. Should the default
button operation need to be changed, all buttons can be reprogrammed to
operate as needed.

Preparing the Keyfob for Use

Attach the keyfob transmitter to any keyring or lanyard. Select the peel-off
labels that display the programming for each button and place them onto the
corresponding keyfob buttons for quick reference. See Figure 2. For easier
label installation use a small flat head screwdriver or X-acto knife to select the
label and apply it to the proper button location as shown in Figure 1. Button
labels can be changed if programming is changed.

LED Communication

When any button is pressed, the LED flashes Green one time for one-half second
to confirm the button press. When the top and bottom buttons are pressed at
the same time, the panel acknowledges with different LED displays to indicate
panel status. The table below describes the LED operation and what the
different color flashes mean.
LED Display
Green, Green
Green, Yellow
Red, Red
Red, Yellow
Yellow, Yellow
Arm (Away)
LED
Top Button
Arm
(Home)
Left
Button
1145 4-Button Layout
Front View
1147 1146
1-Button
2-Button
Layout
Layout
Figure 1: 1140 Series KeyfobTransmitters
What it Means
Disarmed and ready to arm.
Disarmed and trouble.
All system armed.
Armed (Perimeter/Home or Sleep).
System trouble, no acknowledgement, or out of range.
Slot Location
Keyfob
Keyfob
Front
Panic
Right
Button
Disarm
Bottom Button
Connect
Keyring or
Side View
Lanyard Here
Arm (Away)
Top Button
Button Callouts
Identify Default
Programming
Disarm
Bottom Button
Back