Remote Control; Troubleshooting - STEINEL IR Quattro SLIM Series Manual

COM 2
Stay-ON time for switching output 2 HVAC
• Settings 5/10/15 min.
Switch-ON delay for switching output 2 HVAC
Selecting the "Surveillance" setting
• Room surveillance
reduces the sensitivity of the
"Presence" switching output. The
contact only closes on detecting
a pronounced movement, signalis-
ing with a high degree of certainty
that persons are present.
DIM + DALI
Basic brightness
Provides basic illumination for the light intensity (constant-lighting
selected stay-ON time when ambi- controller OFF) or adjusts to the
ent light falls below the selected preselected brightness level (con-
brightness threshold that is set. stant-lighting controller ON). When
This is dimmed to 10% of maxi- no movement is being detected,
mum light intensity. As soon as the detector dims back to basic
a person enters the scene, the brightness after the stay-ON time
detector switches either to 100% expires. This is switched OFF when
Constant-lighting control
Provides a constant level of el of brightness. As daylight
brightness. Detector measures changes, the switched-in artifi-
the prevailing level of daylight cial lighting component is ad-
and activates sufficient artificial justed accordingly. In addition to
light to achieve the required lev- the daylight component, artificial
The stay-ON time remains active.
The switch-ON delay is inactivated.
stay-ON time (10 / 30 min.) has ex-
pired or the daylight component is
sufficient to exceed the selected
level of brightness. In the ON set-
ting, the detector switches basic
brightness ON and OFF as soon as
the level of light falls below the
brightness threshold.
light is also switched ON and OFF
in relation to whether or not per-
sons are present.
- 22 -
Parallel-connected configurations
When using several detectors, they As many as 10 sensors can be
must be connected to the same connected in parallel.
phase!
Master/master
A parallel-connected configuration ness it measures. Delay times and
also permits the use of several brightness thresholds are selected
masters. In this case, each master at each master as required. The
operates the lighting group in ac- switched load is spread among the
cordance with the level of bright- individual masters. Presence is still
Master/slave
The master/slave configuration slave). The level of brightness pre-
permits detection of movement in vailing in the room is only evaluat-
large-type rooms or spaces (load ed at the master. The slaves report
connected = master, no load = movements detected to the mas-

Remote control

Service remote control (RC8):
Using the remote control (optional),
functions can be conveniently EAN no.: 4007841 559410
activated from the floor. User remote control (RC5):
EAN no.: 4007841 592806

Troubleshooting

Malfunction Cause
L
Light does not switch ON
No supply voltage
L
Lux setting too low
L
No movement detection
L
Semi-automatic operation
(Semi)
L
Light does not switch OFF Lux setting too high
L
Stay-ON time running out
L
Interfering heat sources, e.g.
fan heater, open doors and
windows, pets, light bulb/
halogen floodlight, moving
objects
L
4h ON active (LED stays ON
all the time)
detected collectively by all detec-
tors. The presence output can be
picked off from any master.
ter. Lighting or HVAC is switched
ON and OFF by the master only.
Remedy
L
Check supply voltage
L
Slowly increase lux setting
until light switches ON
L
Ensure unobstructed sensor
vision
L
Check detection zone
L
Set to fully automatic
operation (FULL)
L
Reduce lux setting
L
Wait until stay-ON time
elapses; reduce stay-ON time
if necessary
L
Use stickers to mask out
stationary sources of
interference
L
Press button to discontinue
4h ON
- 23 -