Spraying
Spraying
1. Engage gun piston safety lock.
2. Close gun fluid manifold valves A and B.
3. Attach gun fluid manifold. Connect gun air line.
Open air line valve.
28
4. Set PRESSURE RELIEF/SPRAY valves (SA, SB) to
SPRAY
SA
ti2409a
5. Check that heat zones are on and temperatures are
on target, page 25.
6. Press motor
7. Check fluid pressure display while the gun is detrig-
gered and adjust as necessary, page 26.
8. Check fluid pressure gauges (GA, GB) to ensure
proper pressure balance. If imbalanced, reduce
pressure of higher component by slightly turning
ti2728a
PRESSURE RELIEF/SPRAY valve for that compo-
nent toward PRESSURE RELIEF/CIRCULATION
, until gauges show balanced pressures.
GA
ti2543a
.
to start motor and pumps.
GB
In this example, B side
pressure is higher, so
use the B side valve to
balance pressures.
ti9877a
SB
ti9877a
313539F