Graco REACTOR H-VR Operation page 24

Startup
2.
Load fluid with feed pumps
NOTE:
The Reactor is tested with oil at the factory. Flush out
the oil with a compatible solvent before spraying. See
page 38.
a. Check that all Setup steps are complete.
b. Turn on component B agitator, if used.
c. Turn both PRESSURE RELIEF/SPRAY valves
(SA, SB) to SPRAY
SA
d. Start feed pumps.
e. Open fluid inlet valves (FV). Check for leaks.
Do not mix components A and B during startup.
Always provide two grounded waste containers to
keep component A and component B fluids separate.
f. Use feed pumps to load system. Hold gun fluid
manifold over two grounded waste containers.
24
.
SB
ti9877a
FV
ti10972a
Open fluid valves A and B until clean, air-free
fluid comes from valves. Close valves.
ti2484a
313539F