Start Recording - Kenwood XD-753 Instruction Manual

To pause recording
(Main unit only)
REC/ARM
÷ Pressing the key pauses recording after leaving a
non-recorded space of about 4 seconds.
÷ If the key is pressed again in less than 4 seconds after it
has been pressed, recording resumes from that instant.
Select an input source other
than "TAPE A or B" .
4 4
REC/ARM
5 5
Lights
T.EQ
A B
4. Select the source to be recorded.
Press the desired key.
The input source component to
be recorded should be displayed.
÷ If a disc has already been loaded when the CD input is selected, it will starts
to play automatically. In this case, press the stop (7) key to stop it.
÷ When you select DVD/VIDEO (External input), adjust the input level. t

5. Start recording.

1
Start recording.
2
Play (or tune) the input source to be recorded.
Selection of the reverse mode
Each press switches the modes as follows.
1 " " .... Recording stops after having re-
corded both sides of tape.
2 "
" ... Recording stops after having re-
corded both sides of tape.
3 " " ..... Recording stops after having re-
corded one side of tape.
÷ When the "2" transport direction indicator is lit,
recording always stops after having recorded one
side of tape.
Lights
T.EQ
A B
Let's record
REVERSE
MODE
÷ If a disc has already been loaded
when the CD input is selected, it
will starts recording automatically.
÷ Even if deck A is selected, it is
automatically switched to deck B
at the start of recording.
÷ Recording stops automatically
when the tape side(s) to be re-
corded have been fully recorded.
÷ Press the stop (7) key of the cas-
sette deck unit to stop recording
(see the next page).
29