Start Recording - Kenwood XD-751 Instruction Manual

Selection of the reverse mode
REV.MODE
Each press switches the modes as follows.
1 "[" ... Both sides are played back (recorded), and
then the tape stops.
2 """ .. Both sides are played back endlessly.
(The tape stops after recording onto both
sides.)
3 """ .. Only one side is played back (recorded),
and then the tape stops.
4 4
Select an input source other than "TAPE".
REC/ARM
5 5
To pause recording
REC/ARM
Selection of DOLBY NR
The Dolby NR system minimizes the hiss noise heard when
playing tape. When playing a tape prerecorded with Dolby
NR ON, be sure to set the DOLBY NR ON for playback.
Each press switches the modes as follows.
4. Select the source to be recorded.
1 TUNER (Radio)
2 CD
3 TAPE
4 AUX (External input)
(AUX INPUT LEVEL adjustment

5. Start recording.

1 Play (or tune) the input source to be
recorded.
2 Start recording.
÷ Recording stops automatically when the tape
side(s) to be recorded have been fully recorded.
÷ The beat cancel function can be used when
recording MW broadcasts.
÷Pressing the key pauses recording after leaving a non-recorded space of about 4 seconds.
÷If the key is pressed again in less than 4 seconds after it has been pressed, recording resumes
from that instant.
(Noise Reduction)
Lit when "DOLBY NR" is ON.
DOLBY NR
1 "1 NR" ON ............. DOLBY NR is used.
2 "1 NR" OFF ............ DOLBY NR is not used.
The input source component to be recorded should be displayed.
C D
o
)
÷ When the CD input is selected and if a disc has
been set in the CD player, its playback starts
immediately.
C D
1 2
¤
Let's record
XD-SERIES (En)
T A P E B 0
NR
0 1 0 0 0
1 2 3
0 1 0 1 2
3
Lights
31