Start Recording - Kenwood XD-A83 Instruction Manual

To pause recording
(Main unit only)
REC/ARM
Pressing the key pauses recording after leaving a
non-recorded space of about 4 seconds.
If the key is pressed again in less than 4 seconds after it
has been pressed, recording resumes from that instant.
Select an input source other
than "TAPE A or B".
4 4
REC/ARM
5 5
Lights
T.EQ
A B
4. Select the source to be recorded.
Press the desired key.
C
The input source component to
be recorded should be displayed.
If a disc has already been loaded when the CD input is selected, it will starts
to play automatically. In this case, press the stop (7) key to stop it.
When you select DVD/VIDEO (External input), adjust the input level. t

5. Start recording.

1
Start recording.
2
Play (or tune) the input source to be recorded.
Selection of the reverse mode
Each press switches the modes as follows.
1 " " .... Recording stops after having re-
corded both sides of tape.
2 "
" ... Recording stops after having re-
corded both sides of tape.
3 " " ..... Recording stops after having re-
corded one side of tape.
When the "2" transport direction indicator is lit,
recording always stops after having recorded one
side of tape.
D 0 1 1 : 1 2
Lights
T.EQ
A B
Let's record
REVERSE
MODE
If a disc has already been loaded
when the CD input is selected, it
will starts recording automatically.
Even if deck A is selected, it is
automatically switched to deck B
at the start of recording.
Recording stops automatically
when the tape side(s) to be re-
corded have been fully recorded.
Press the stop (7) key of the cas-
sette deck unit to stop recording
(see the next page).
29