Table of Contents
Advertisement
Operation of remote control unit
20
Loading batteries
1 Remove the cover.
XD-6...series
XD-7...series
XD-8...series
Operation
Plug the power cord into the mains power outlet and
press the on/standby (
control unit to turn power ON. After the power has been
turned ON, press the desired key.
To turn power off, press the on/standby(
again.
The power mode enters the STANDBY mode in which
the "STANDBY" indicator lights up. (The "TIMER" in-
dicator also lights in this mode if a timer program has
been activated.)
÷ When pressing more than one remote control keys
successively, press the keys securely by leaving an
interval of 1 second or more between keys.
1.The provided batteries are intended for use in operation checking, and their service life may be short.
2.When the remote controllable distance becomes short, replace both of the batteries with new ones.
Notes
Notes
3.If direct sunlight or the light of a high- frequency fluorescent lamp (inverter type, etc.) is incident to the remote
sensor, malfunction may occur. In such a case, change the installation position to avoid malfunction.
CHANNEL SPACE setting
(Except for the U.S.A., Canada, U.K., Europe, Australia and Russia)
The space between radio channels has been set to the
one that prevails in the area to which the system is
shipped. However, if the current channel space setting
does not match the setting in the area where the sys-
tem is to be used, for instance when you move from
area 1 or area 2 shown in the following table or vice
versa, proper reception of AM/FM (MW/FM) broad-
casts cannot be expected. In this case, change the chan-
nel space setting in accordance with your area by re-
ferring to the following table.
Area
USA, Canada and South
1
American countries
2
Other countries
2 Insert batteries.
÷ Insert two R6 ("AA"-size) batteries
following the polarity indications.
POWER) key of the remote
POWER) key
CHANNEL
SPACE freq.
FM : 100 kHz
AM :
10 kHz
FM :
50 kHz
AM :
9 kHz
3 Close the cover.
Operating range
(approx.)
6m
1 Select the TUNER input.
2 While holding the SELECT key depressed, turn
the SOUND CONTROL jog dial to select the
system mode.
C
1 "FM100/AM10 kHz" STEP,
2 "FM 50 /AM 9 kHz" STEP,
F
M 1 0 0 / A M 1
0
÷ The "AM" display is variable depending on the model
(country or area), and "MW" may be displayed in
some areas.
3 Establish the selection.
XD-SERIES (EN/M,T)
2
1
Remote sensor
30
30
˚
˚
SELECT
F
M
5 0 / A M
9
ENTER
Hide quick links:
Advertisement
Table of Contents
