Kenwood XD-852 Instruction Manual page 37

4
Check the programmed tracks
(and replace, add or delete tracks as
required).
To check:
To replace a track in the program:
1 Select the programmed disc
or track to be replaced and
press the SELECT key.
SELECT
2 Select a disc or track to re-
place the disc or track selected
above (step 3-1and 2).
To add a track to the program:
1 Select the display as shown
on the right and press the
SELECT key.
SELECT
2 Perform the same operations
as in step 3-1and 2.
To delete a track from the program:
1 Select the programmed disc
or track to be cleared and
press the SELECT key.
SELECT
2 Select "clear" and press the
SELECT key.
5
Enter it.
ENTER
(Playback starts from the first programmed
track (program No. 1))
÷ Turn the MULTI CONTROL jog dial during program
playback to stop to the previous or next programmed
track.
÷ When the jog dial is rotated a little in the direction of
counterclockwise once during playback, the track
being played will be played from the beginning.
÷ To check (replace, add or delete) programmed
tracks after playback, perform the operations in
steps 2 and 4.
P 0 1 D 1 T 0
÷ The programmed tracks are displayed in sequence.
P 1 2 D 3 T 0
P 1 2 D 3 T 0
÷ The blinking item can be replaced.
Display when 12 tracks have been programmed
P 1 3 D ? T ?
÷ The added track number is added to the end of the
existing program.
P 1 2 D 3 T 0 4
To quit the program mode
1
Select "CD Program Play".
MENU
2
Press the MENU key.
MENU
÷ If the key is pressed during playback, normal playback in
order of tracks resumes from the current track.
÷ The program mode can also be canceled by pressing
the 0 OPEN key.
Playback of CD
XD-SERIES (EN/M,T)
2
4
4
?
P 1 2 c l e a r
SELECT
Goes off
37