Relay Play - Kenwood XD-852 Instruction Manual

28

Relay play

When tapes are set in the decks A and B and the re-
verse mode is set to "
the second deck will be started automatically after
play of the first deck has been completed. Tape play
will be repeated alternately.
÷ Relay play is not possible in the reverse modes "
and " ".
÷ If a tape is loaded only in either deck, playback stops
after having played both sides of the tape.
A tip for use of the tape counter
The tape counter is set to "0000" when a cassette tape
is loaded. By writing down the counter reading in case
you want to interrupt recording (playback) in the
middle of the tape, the memo will be helpful as a ref-
erence for locating the same position when continu-
ing the recording (playback) the next time. The tape
counter figure decrements during recording or play-
back of the back side (while the 2 tape transport in-
dicator is lit).
To set the tape counter to "0000", open the cassette
holder once. Then the counter will be reset.
" (play of both sides), play of A
"
T A P E
Let's put out some sound
XD-SERIES (EN/M,T)
A
0 0 0 0