Miele PWM 908 Operating And Installation Instructions page 88

Supervisor level
If the automatic load control is
deactivated, the machine will always
carry out the program sequence based
on a full load.
Factory default: On
Controlled energy cons.
With this option selected, the machine
will optimize the energy it uses in the
Whites, Cottons, and Minimum iron
programs.
Factory default: On
Service
Clean drain pump (LP)
The user sees a message when the
drain pump filter has to be cleaned.
The message is displayed every
500 operating hours.
The message appears at the end of the
program.
Factory default: Off
88
Service interval
Service information can appear in the
display. You can configure whether a
date or the number of operating hours
is displayed.
You can select up to 3 messages with
their own text.
Your message is displayed at the end of
the program and can be acknowledged
with OK. The same message appears at
the end of the next program.
Settings
This setting allows you to determine the
interval (by hours or date) at which the
message appears.
– Factory default: Off
– By time
You can then select a time interval
from 1–9,999 hours.
– By date
You can then enter a date.
Message text
Enter your message for your planned
maintenance work.
Reset the display
The message appears until the display
is permanently reset. The message then
appears again once the next interval is
reached.