Miele PWM 908 Operating And Installation Instructions page 68

Installation and connection
Installation locations
Side view
44 9/16" (1,132 mm)
28 1/8" (714 mm)
43 1/3" (1,000 mm)
Washer-dryer stack
The washing machine can be installed
as a washer-dryer stack together with a
Miele Tumble Dryer. A stacking kit
(APCL 001, optional accessory) is
required for this.
68
Installation on a base
The washing machine can be installed
on a steel base (open or closed, e.g.
APCL 002, APCL 003, APCL 005, APCL
007, APCL 011 or APCL 012, available
as an optional Miele accessory) or on a
concrete base.

Injury can occur if the washing
machine has not been adequately
secured.
When installing the machine on a
base, there is the danger of the
washing machine falling off the base
during spinning.
Secure the washing machine using
the clamps supplied.
Installation notes
This washing machine is not suitable
for building under.

Risk of damage due to moisture
ingress.
Moisture can damage electrical
components.
Do not install the machine near or
directly above an open gully or floor
drain.
The washing machine must not be
connected to devices such as timers
which would switch it off
automatically.