Miele PWM 908 Operating And Installation Instructions page 89

External applications
Empty sensor
External hardware is connected via the
Miele XCI Box.
A contact at suction lances can be
used to detect whether external
detergent containers are empty. A
message appears if a container is
empty.
– Off (factory default)
– Normally open contact
The suction lances are equipped with
a normally open contact.
– Normally closed contact
The suction lances are equipped with
a normally closed contact.
Early warning counter
External hardware is connected via the
Miele XCI Box.
An internal counter reports when an
external dispenser container is almost
empty. The counter in question then
has to be reset.
Supervisor level
Peak-load signal
External hardware is connected via the
Miele XCI Box.
The peak-load negotiation function
enables the washing machine to be
connected to an energy management
system. When a signal is registered,
the washing machine's heater is
switched off for a short period.
The washing machine may only be
operated with a peak-load system if this
system is connected to the washing
machine via the Miele XCI Box.
– No function (factory default)
– Peak load with 230 V
– Peak load with 0 V
Peak-load prevention
The peak-load negotiation function
can be deactivated with disinfection
programs. When a signal is registered,
the washing machine's heater is not
switched off.
Factory default: Off
89