8.1 CONVERSION END CAPS KIT MOUNTING
Front hub
Remove the pressure end caps installed on the front hub (standard TA
12x100 mm) and replace them with those you need (QR 100 mm, TA 15 mm)
Install the end cap with the smaller flange diameter (1) on the disc brake rotor
side and the one with the bigger flange diameter (2) on the opposite side
Make sure the washer (3) is correctly placed in its seat on the end cap (4)
before inserting caps into the hub
(1)
(3)
(4)
Rear hub
Unscrew the end caps fastened to the rear hub axle (standard TA 12x142 mm)
with appropriate wrenches and replace them with those you need (QR 135
mm)
Install the longer end cap (1) on the disc brake rotor side and the shorter one
(2) on the opposite side (drive side)
Make sure the washer (3) is correctly placed in its seat on the end cap (4)
before inserting the caps into the hub
(1)
(3)
(4)
(3)
(2)
(4)
(3)
(2)
(4)
11