Bosch DICENTIS Hardware Installation Manual page 11

DICENTIS
8.
9.
10. Multimedia device (DCNM-MMD / DCNM-MMD2)
Participants can use their DICENTIS Discussion device to contribute to a meeting: DCNM-D,
DCNM-DVT, DCNM-DSL, DCNM-DE.
A typical camera setup in a DICENTIS Conference System consists of:
Figure 3.2: Typical camera setup
.....
Bosch Security Systems B.V.
System Network Cable (DCNM‑CBxxx):
– Connects DICENTIS devices, the Audio processor and powering switch, and one or
more Powering switches to each other.
Multimedia device (DCNM-MMD / DCNM-MMD2)
– This device is used for "system power on/off". It is always connected to the powered
socket of the Audio processor and powering switch or Powering switch.
Note: Only one DICENTIS Multimedia device should be connected here.
– This device is used via a "Power over Ethernet" (PoE) Ethernet switch.
Note: Only one DICENTIS device should be connected here.
1 H.264 encoder to encode the HD SDI
video to H.264 if the video camera is
not able to supply the supported
H.264 stream
3 Projector to show the active speaker
on the large screen
5 DCNM-SERVER
7 DCNM-APS2
HD-SDI (coax cable)
Hardware Installation Manual
System installation overview | en
2 HD-SDI switcher to switch the HD-SDI
streams of the cameras
4 Video camera (Onvif Profile-S
compatible camera, Sony, Panasonic)
6 L3 Ethernet switch
8 DCNM-MMD2, displaying the active
speaker on the device
----- Ethernet TCP/IP
11
2021.01 | V2.2 |