User Guide
Figure 259: Remove PSU
c. Uninstall the remaining PSU in the same way the first was uninstalled.
Step 5 : (Optional) Remove the device blanks from the enclosure.
a. From the front of the rack, press the release button on the front of the device blank. The
release handle will eject outward.
Figure 260: Device Blank Release Operation
Attention: This step is optional because not all configurations contain device
blanks. If the configuration contains a device blank, this step will be required.
Blanks must be installed in any empty slots to ensure proper cooling.
3. Management
3.2 Part Replacement
148