Table of Contents
Advertisement
User Guide
Figure 245: OpenFlex F3x00 Slot Identification
Step 10 : (Optional) Install the device blanks into the enclosure.
a. Press the release button on the front of the OpenFlex F3x00 . The release handle will eject
outward.
Figure 246: OpenFlex F3x00 Release Operation
b. Gently slide the device blank into a chassis device blank slot until the release handle is
engaged with the chassis. When the handle lifts up slightly, it is an indicator that the release
handle is engaged with the chassis.
Attention: This step is optional because not all configurations contain device
blanks. If the configuration contains a device blank, this step will be required.
Blanks must be installed in any empty slots to ensure proper cooling.
3. Management
3.2 Part Replacement
141
Advertisement
Table of Contents
