Additional System Check - Harmar Mobility SL600 Installation & Service Manual

ADDITIONAL SYSTEM
CHECK
1. After the successful testing of all safety
switches, sit on the lift and operate to the
top of the stairs. Keeping the control switch
pressed continuously, the lift should gently
decelerate and then stop at the top of the rail.
2. As a final adjustment, sit on the lift and do
two (2) complete up trips and stop with
the chair at the bottom. Then tighten the
compression screw in the top end plate, then
run the chair to the top and again tighten
the compression screw. Run the chair to
the middle and do a final tightening of the
compression screw.
3. Drive the lift to the bottom, keeping the
control switch pressed all the time, and check
that the lift gently decelerates and stop so the
footrest pan is clear of the floor. If necessary
adjust the limit cams with a 5/64" Allen wrench.
4. Move the lift about 3' from either the top
of bottom of the rail. After 30-seconds the
beep indicating that the lift is not positioned
on a charge point. The beep will stop after
30-seconds.
5. Test the seat swivel at the top using the levers
and swiveling the seat towards the landing
and stop the seat at 35� and 85�. The seat
swivel levers will release into a locked position
at each of these angles. The lift will not
operate in any of these positions if the control
switch is pressed. Return the seat to its
normal position and the lift will now operate
normally.
PINNACLE STAIR LIFT: SECTION 5
COMPLETION PROCEDURES
SL600 PINNACLE STAIR LIFT:
Install Manual
30SEP2020 | 76015 REV F
21