Footrest And Seat Installation - Harmar Mobility SL600 Installation & Service Manual

5. Install the end plate to the top of the track
with the four (4) self-cutting Torx screws using
the supplied T30 Torx bit. Making sure not to
pinch the wires on the pigtail .
NOTICE
Too much torque applied to these screws may result
in damage. Take your time and apply grease to
threads.
6. Install one of the rack precompression screws
in the threaded hole in the top plate of the
rail, and tighten it as firmly as possible by
hand with a 5/32" Allen wrench. Make sure to
use the 1 1/4" precompression screw.
See Figure 4-22.
Figure 4-22
7. Plug in the power supply at either end of the
rail, depending on the closest or most
convenient location of a wall power supply.
Minimize wire length and intrusion.
WARNING
!
Use care in routing the charger lead. If possible,
secure along or inside wall to avoid the creation of
a tripping hazard.
PINNACLE STAIR LIFT: SECTION 4
FOOTREST AND SEAT
INSTALLATION
1. Remove the footrest from the box and use the
installation switch to drive the chassis
downward to a position about 6" clear off the
floor. This will provide a safe area to install
and adjust the footrest. Do not drive the unit
into bottom stop. See Figure 4-23.
Figure 4-23
2. Turn the red "On/Off" switch located on the
top of the chassis to the "Off" position.
3. Position the footrest onto the two (2) seat-
leveling bolts on the outside of the chassis by
aligning the large opening at the slot ends of
the footrest. See Figure 4-24.
Figure 4-24
4. Ensure that the footrest is fully engaged.
5. Check that the height of the seat base is
correctly set for the intended user. A seat height
guide is provided behind the plastic footrest
shroud. Consult with the client and use an
existing chair or walker with armrest as a guide.
SL600 PINNACLE STAIR LIFT:
30SEP2020 | 76015 REV F
INSTALLATION
Install Manual
13