ABB Welcome IP H8236 Series Product Manual page 159

[3] Display the zone number to be set.
[4] Select the sensor from the drop-down list. It can be set to "Emergency alarm", "Door
magnetic", Infrared", "Gas", "Smoke", "Other" or "None".
[5] Select the location from the drop-down list.
[6] Select the trigger type from the drop-down list. It can be set to "Instant", "Delay", "24 hour"
or "Transfer delay" (see details on the next page).
[7] Tap to select the alarm mode. It can be selected from "Arm for stay", "Arm for away" and
"Arm for rest".
[8] Select the linked zone from the drop-down list. With this setting, the alarm zone is combined
with the other alarm zone. Fox example, zone 1 is linked to zone 2. Both zones must be set
to the same trigger type. Either of them can be triggered first, and the other zone will then
also be triggered within 20 s, an alarm will be sounded and an alarm message will be sent
to the guard unit and the management software.
[9] Select the linked camera from the drop-down list. When the zone is triggered, the camera
will record a 15 s video and save it to the SD card if an SD card has been inserted.
Product manual 2TMD041800D0002
Commissioning
│159