Default Lock Setting - ABB Welcome IP H8236 Series Product Manual

8.9.5

Default lock setting

Please follow the steps below:
[1] On the "Outdoor station settings" screen, select lock type from the drop-down list. It can be
set to "Lock-GND", "NO-NC-COM" or "IP Actuator".
[2] If lock type = "IP actuator", you need to set lock type from the drop-down list. It can be set to
"Power lock" or "Relay lock" (optional).
[3] If lock type = "IP actuator", you need to set device number of the IP actuator (optional).
[4] Enter the unlock time for the power lock (default 5 seconds).
[5] Enter the unlock time for the signal lock (default 5 seconds).
[6] Tap " " to exit the setting, tap "OK" to save the settings.
Product manual 2TMD041800D0002
Commissioning
│172