Tyco Electronics AMP NETCONNECT MRJ21 Instruction Sheet

12-24 Screw
(4 Places)
EIA Rack
AMP NETCONNECT* AMPTRAC*
(Ref)
Printed Circuit (PC) Board Subassembly
(2 Places) (AMPTRAC Patch Panel Only)
Right Side AMPTRAC
Port Identification (AMPTRAC
Patch Panel Only)

1. INTRODUCTION

MRJ21 48–Port 10/100/1000BASE–T angled patch
panels are designed to be mounted onto a standard
483–mm [19–in.] Electronic Industries Alliance (EIA)
rack or equipment cabinet as shown in Figure 1.
The AMPTRAC patch panel is designed for use with
the AMP NETCONNECT AMPTRAC system. Read
these instructions thoroughly before starting
Installation.
NOTE All numerical values in this instruction sheet are
in metric units [with U.S. customary units in
i
brackets]. Dimensions are in millimeters [and
inches]. Figures are not drawn to scale.
NOTE
For the AMPTRAC patch panel, these
instructions assume that the reader understands
i
the operation of equipment and software used
with the AMPTRAC system.
AMPTRAC Retrofit Kit 1479853–1 can be installed
onto the standard patch panel to enable the patch
panel to be connected to the AMP NETCONNECT
E
2007 Tyco Electronics Corporation, Harrisburg, PA
All International Rights Reserved
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
AMP NETCONNECT* MRJ21* 48-Port
10/100/1000BASE-T Angled Patch Panels
1777052-1 and 1777053-1
HDP-22 Connector
(2 Places) (AMPTRAC
Patch Panel Only)
Standard Patch Panel
1777052-1
Figure 1
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
Front of Patch Panel
Port Identification
(16 Places)
Back of Patch Panel
Port Identification
(8 Places)
MRJ21 Receptacle
(8 Places)
AMPTRAC Patch Panel
1777053-1
AMPTRAC system. Back Cable Manager Kits
1933352–[ ] or Wiring Distribution Bracket Kit
557548–1 must be used to support the cable.
To obtain information on AMP NETCONNECT
products, call PRODUCT INFORMATION at the
number at the bottom of this page, or visit the
AMP NETCONNECT website at
www.ampnetconnect.com.
Reasons for reissue of this instruction sheet are
provided in Section 6, REVISION SUMMARY.

2. DESCRIPTION


Each patch panel contains eight MRJ21 receptacles
(two per 2 6 RJ45 connector assembly). The ports
are identified by numbers printed on the front and
back of the patch panel. Four 12–24 screws are
included to mount the patch panel to the rack.
In addition, the AMPTRAC patch panel has two pc
board subassemblies and two HDP–22 connectors
to enable the patch panel to connect to the
AMP NETCONNECT AMPTRAC system.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at
Instruction Sheet
408-8963
19 JUN 08 Rev D

2 6 RJ45 Connector
Assembly (4 Places)
Left Side AMPTRAC
Port Identification (AMPTRAC
Patch Panel Only)
1
of 2
www.tycoelectronics.com
LOC B