Tyco Electronics 408-10254 Instruction Sheet

Advertisement

1. INTRODUCTION

NOTE
This product is for use in a restricted access
location only.
i
This instruction sheet provides installation guidelines
for Tyco Electronics Active Cables for both CX4
QSFP connectors. Proper handling procedures
should be exercised when transporting or installing
the cables. Operation of the product must be
maintained within the 0 to 60 C operating ambient
temperature range.
D
CX4 connector is also known as Infiniband 4X or
SFF–8470.
NOTE
This product does not contain any adjustable
controls.
i
DANGER
Use of controls or adjustments or performance of
procedures other than those specified herein may
result in hazardous radiation exposure.
1A
Align CX4 Plug
with Receptacle
IEC60825-1
E
2008 Tyco Electronics Corporation, Harrisburg, PA
All International Rights Reserved
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
PARALIGHT*
Active Optical
Cable Assemblies
NOTE
i
2. INSTALLATION GUIDELINES FOR CX4 STYLE
CONNECTOR ENDS
D
Refer to Figure 1 for installation of CX4 style
and
connectors.
1. Correctly align the CX4 plug with the receptacle
as shown in Figure 1A.
2. Insert the plug into the receptacle until it
bottoms. See Figure 1B.
3. To remove the plug from the receptacle, pull on
the "release handle" in the indicated direction until
the connector is removed as shown in Figure 1C.
3. INSTALLATION GUIDELINES FOR QSFP STYLE
CONNECTOR ENDS
Refer to Figure 2 for installation of QSFP style
connectors.
1. Correctly align the QSFP plug with the
receptacle as shown in Figure 2A.
Insert Plug into Receptacle
Until It Bottoms
1C
Figure 1
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
408-10254
Product is to be installed in accordance with both
National and Local regulations and/or
requirements or other authority having
jurisdiction.
1B
Pull on Release
Handle" to Remove
(Do NOT Pull on
Cable)
This controlled document is subject to change.
For latest revision and Regional Customer Service,
www.tycoelectronics.com
visit our website at
Instruction Sheet
22 DEC 08
Rev A
1
of 2
LOC B

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 408-10254 and is the answer not in the manual?

Questions and answers

Summary of Contents for Tyco Electronics 408-10254

  • Page 1 2. INSTALLATION GUIDELINES FOR CX4 STYLE CONNECTOR ENDS This instruction sheet provides installation guidelines Refer to Figure 1 for installation of CX4 style for Tyco Electronics Active Cables for both CX4 connectors. QSFP connectors. Proper handling procedures should be exercised when transporting or installing 1.
  • Page 2 This product is classified as a Class 1M Laser product in accordance with IEC 60825–1:1993+A1+A2 and 5. REVISION SUMMARY complies with 21CFR 1040.10 and 1040.11 except for deviations pursuant to laser notice No. 50, dated S Initial release of document 24–Jun–2007. of 2 Tyco Electronics Corporation...

Table of Contents