Toro Greensmaster eTriFlex 3370 Operator's Manual page 48

Figure 56
1. Reel motor
2. Spline shaft
8. Mount a grass basket onto the basket hooks on
the suspension arm.
9. Repeat this procedure for the other cutting units.
10. Connect the main-power connectors; refer to
Main-Power Connectors (page
Removing the Cutting Units
1. Park the machine on a clean, level surface,
set the function-control switch to the N
position and use the lift/lower joystick to lower
the cutting units.
2. Engage the parking brake, shut off the machine,
and remove the key.
3. Disconnect the main-power connectors; refer to
Main-Power Connectors (page
g036122
3. Cavity
4. Motor-retaining bar
20).
EUTRAL
20).
CAUTION
If you do not disconnect the power to the
machine, someone could accidentally
start the cutting units, causing serious
injury to hands and feet.
Always separate the disconnect the
main-power connectors before working
on the cutting units.
4. Push the motor retaining bar out of the slots on
the motor toward the cutting unit and remove
the motor from the cutting unit.
1. Reel motor
5. Move the motor to the storage location on the
front of the suspension arm
Note:
When sharpening, setting the
height-of-cut, or performing other maintenance
procedures on the cutting units, store the cutting
unit reel motors in the storage location on the
front of the suspension arms to prevent damage
to them.
48
Figure 57
2. Motor-retaining bar
(Figure 58).
Figure 58
g036123
g036124