Toro Greensmaster eTriFlex 3370 Operator's Manual page 20

About (cont'd.)
B
ATTERY
CAN B
US
T 3
RACTION
Note:
Protected under Protected
Menus—accessible only by entering PIN;
refer to Accessing Protected Menus (page
Accessing Protected Menus
Note:
The factory default PIN code for you machine
is either 0000 or 1234.
If you changed the PIN code and forgot the code,
contact your authorized Toro distributor for assistance.
1. From the M M
AIN
scroll down to the S
right button.
2. In the S
ETTINGS
scroll down to the P
the right button.
3. To enter the PIN code, press the center button
until the correct first digit appears, then press
the right button to move on to the next digit.
Repeat this step until the last digit is entered and
press the right button once more.
4. Press the middle button to enter the PIN code.
Wait until the red indicator light of the InfoCenter
illuminates.
Note:
If the InfoCenter accepts the PIN code
and the protected menu is unlocked, the word
"PIN" displays in the upper right corner of the
screen.
You have the ability to view and change the settings in
the Protected Menu. Once you access the Protected
Menu, scroll down to the Protect Settings option. Use
the right button to change the setting.
•
Setting the Protect Settings to O
view and change the settings in the Protected
Menu and view the CU motor and traction
information screens without entering the PIN code.
•
Setting the Protect Settings to O
protected options and requires you to enter the PIN
code to change the setting in the Protected Menu.
After you set the PIN code, rotate the key switch to
the O position and back to the O
FF
and save this feature.
Lists the software part number
and the revision version for
the battery.
Lists the machine
communication bus status.
Lists the software part number
and the revision version for
the 3-Wheel Drive Kit (if
equipped).
20).
, use the center button to
ENU
M and press the
ETTINGS ENU
M , use the center button to
ENU
M and press
ROTECTED ENU
allows you to
FF
hides the
N
position to enable
N
Note:
Rotate the key switch to the O
then to the O position to lock the protected menu.
N
Setting the Machine Configuration Passcode
You can set a passcode on the InfoCenter so that an
operator cannot access specific InfoCenter screens
without it. Refer to
Menu Items (page 18)
are passcode-protected.
1. From the S
ETTINGS
S .
ETTINGS
2. Set P
ROTECT
3. When prompted, enter a 4-digit passcode.
4. Turn the ignition key to the O
the code.
Note:
If you forget the user defined passcode,
you can obtain a temporary passcode from your
authorized Toro distributor.
Understanding the Fault-Log Indicator
If a fault occurs, a fault code appears on the
InfoCenter screen and a red flashing light appears
above the screen.
The fault is stored in a log entry located in the F
menu, which you or your distributor can use to identify
the issue that prompted the fault.
For a list of faults, refer to the Service Manual or your
authorized Toro distributor.
Main-Power Connectors
Before you charge the machine, work on the machine,
or install, remove, or work on the cutting units,
disconnect the machine from the power supply by
separating the main-power connectors
located at the base of the roll bar on the left side of
the traction unit. Plug the connectors together before
operating the machine.
20
position and
FF
Understanding the InfoCenter
for the InfoCenter screens that
menu, select P
ROTECT
S to O .
ETTINGS N
position to save
FF
(Figure
AULTS
25),