Toro Greensmaster eTriFlex 3370 Operator's Manual page 36

Recommended Temperature Range for
Charging
Charging range
Low-temperature charging
range (Reduced Current)
High-temperature charging
range (Reduced Current)
1. Park the machine in the designated location for
charging.
2. Engage the parking brake and move the
function-control switch to the N
3. Ensure that the cutting units are disengaged
and lower them to the ground.
4. Shut off the machine and remove the key.
5. Disconnect the power from the machine by
separating the main-power connectors; refer to
Main-Power Connectors (page
6. Ensure that the connectors are free of dust and
debris.
7. Slide the charger-output connector into the
charger connector on the machine
Note:
The machine connector is located below
the main-power connector that is secured to the
machine.
1. Charger connector
8. Connect the charger power cord to a power
source; refer to Connecting to a Power Source
(page 35).
0° to 45°C (32° to 113°F)
-5° to 0°C (23° to 32°F)
45° to 60°C (113° to 140°F)
EUTRAL
20).
(Figure
Figure 35
2. Machine connector
9. Observe the charger to ensure that the batteries
are charging.
Note:
should be flashing and the charging-output
indicator light should illuminate.
10. Disconnect the charger when the machine
reaches a sufficient level; refer to
the Charging Process (page
Monitoring the Charging Process
and Troubleshooting
position.
Note:
The LCD status display displays messages
during the course of charging. Most are routine.
If there is a fault, the error indicator light will flash
amber or a solid, light red. An error message will
appear in the InfoCenter 1 digit at a time, starting with
the letter E or F (e.g., E-0-1-1).
To correct an error, refer to
If none of these solutions correct the issue, contact an
authorized Toro distributor.
35).
Completing the Charging Process
When charging is complete, the battery-charging
indicator light
charging-output indicator light disappears.
1. Disconnect the charger connector from the
machine connector.
2. Place the charger connector and cord in a
storage position that avoids damage.
3. Ensure that the main-power connectors are
clean.
4. Connect the main-power connectors; refer to
Main-Power Connectors (page
5. Turn on the machine; refer to
Machine (page
6. Verify the charge level; refer to
InfoCenter LCD Display (page
g292546
36
The battery-charging indicator light
36).
Troubleshooting (page
(Figure 34) shows solid green and the
27).
Completing
52).
20).
Turning On the
Using the
16).