Receiving The Product; Transporting The Product; Inspecting The Product; Storing The Product - Grundfos SRG 60 Hz Installation And Operating Instructions Manual

Starting-up the product
CAUTION
Pressurized System
Minor or moderate personal injury
- As pressure may have built up in the oil chamber,
do not remove the oil level bolt until the pressure
has been fully relieved.
Make sure that no persons can fall into the tank.
Servicing the product
Before starting work on the pump,
– make sure that the fuses have been removed or
the mains switch has been switched off
– make sure that the power supply cannot be
accidentally switched on
– make sure all rotating parts have stopped
moving.
CAUTION
Biological hazard
Minor or moderate personal injury
- Flush the pump thoroughly with clean water and
rinse the pump parts in water after dismantling.
CAUTION
Pressurized system
Minor or moderate personal injury
- As pressure may have built up in the oil chamber,
do not remove the oil level bolt until the pressure
has been fully relieved.
Fault finding the product
Before starting work on the pump,
– make sure that the fuses have been removed or
the mains switch has been switched off
– make sure that the power supply cannot be
accidentally switched on
– make sure all rotating parts have stopped
moving.
4

4. Receiving the product

4.1 Transporting the product

The individual components of the pump must be packed carefully
to prevent any damage to the surface protection during
transportation.
Make sure that the pump cannot roll or fall over.
Before attempting to lift or otherwise handle the
individual components of the pump, observe any
local regulations that set limits for the weight of the
components to be lifted manually by individuals, i.e.
handled without the use of lifting equipment.
All lifting equipment must be rated for the purpose
and checked for damage before any attempts to lift
the components are made. The lifting equipment
rating must under no circumstances be exceeded.

4.2 Inspecting the product

Do not install a damaged pump.
On delivery, the pump and any accessories supplied with it must
be checked for transport damage. This also applies when the
equipment is delivered to the installation site.
If the pump or any accessories have been damaged during
transportation, contact your local Grundfos company before
continuing to install the equipment. Do not dismantle a damaged
new component for further inspection, unless instructed by your
local Grundfos company.
The packaging material must be disposed of according to local
regulations.

4.3 Storing the product

The pump must be stored in a dry location in which the
temperature is not subject to major fluctuations.
If the pump has been stored for more than one year, the gearbox
oil must be changed. The oil must be changed even if the pump
has never been in use. This is necessary because of natural
aging of mineral oil lubricants.