Table of Contents
Advertisement
2. Initial Operation
On the back of the UNGUATOR® Q you will find the interface for the power cord. The power
switch "O/I" is also the emergency switch and it is located at the base of the machine, on
the right side. Initially check if the power switch of the Unguator® is switched off. Second,
connect the power cable to the device, and finally connect the power cable to the outlet.
Now you can turn the power switch of the UNGUATOR ® QMS on using the "I / O". The device
is ready to be used.
During cold weather condition, plan in advance 30 minutes to allow the UNGUATOR® Q to
acclimate.
3. Display-operation
The face of the UNGUATOR® Q device shows both a panel with four keys "Esc", "-", "+", ok"
for manual control or command input and a display screen. After turning the UNGUATOR® Q
on pressing the main power switch, a splash screen appears on the display. The splash screen
of your device might vary from brelow picture 34. The top bar shows the total number of
preparations and current software version code of the device. By pressing any key the "Start
Menu" will appear.
Pic. 2: Display with splash screen
4. Menu guide
On the right of the UNGUATOR® Q face you will find a panel with keys "Esc", "-", "+" and "ok".
By operating the keys "+" or "-" you may move up and down the navigation bar. Pressing
"ok" you may select and confirm. Pressing the "Esc" key you move back one step.
Additional options...
3
Advertisement
Table of Contents
