Table of Contents
Advertisement
The input of the rpm is assigned to the numbers 0-9, in which each number correlates to a
defined rpm value:
Level
0
1
Rpm
0
600
6.10 Operating errors
The quality assurance system of the UNGUATOR® Q makes sure that operating errors shall be
sensitively registered and displayed. If a problem occurs the display will show the following
error message:
"Mixing tool not locked in place", "Lifting motor overload" and "Mixing motor overload".
If necessary switch off the device after an operating error. The UNGUATOR® Q device will
generally function normally again after remedy.
Irreversible software faults caused by current transients or strong electromagnetic fields in
the vicinity can only be remedied by authorized customer service points.
For functionally testing reasons the UNGUATOR® Q has to be switched off first. The device
can be switched on again after 20 seconds. Please make sure that no UNGUATOR® MB is
attached to the device during start up or rebooting process. We recommend changing the
UNGUATOR® jar size for the initial functionality testing process, and e.g. running a mixing
process with a filled UNGUATOR® jar size 30 or 50ml.
Please contact your local UNGUATOR® dealer for any malfunctions that cannot be remedied
using above information to troubleshoot.
UNGUATOR® Mixing blades (MB)
The UNGUATOR® Q has been tested with the UNGUATOR® MB's that were initially enclosed,
centered, and aligned.
All UNGUATOR® MB's delivered after the year 1996 are compatible with the UNGUATOR®
Q . Please do not use any bent or damaged UNGUATOR® MB. Other UNGUATOR® MB used,
rather than the ones supplied with the UNGUATOR® Q may cause problems of coupling. If
this is the case, we recommend contacting your local UNGUATOR® dealer.
31
2
3
4
800
1000
1200
Tab. 9: Number/Rpm correlation
5
6
7
1400
1650
1900
8
9
2150
2400
Advertisement
Table of Contents
