Operation Mode "Auto - Gako Unguator e/s Operating Instructions Manual

Step
0
1
2
3
4
Tabelle 3-1: Value table of the speed steps
This is described in the two following subsections Operating Mode "AUTO" and
Operating Mode "HAND".
3.1 Operating Mode "AUTO"
®
The UNGUATOR
through the opening of the oscillation arm. Then the male thread of the UNGUATOR
Lid is screwed into the oscillation arm. Pressing the button "Start/Stop" will initiate the
mixing process after the UNGUATOR
the oscillation arm.
The oscillation arm will automatically move upward and the UNGUATOR
be coupled to the bayonet receptor of the mixing motor. A sensor will ensure that a
®
UNGUATOR MB has been inserted and will immediately switch off if the
UNGUATOR ® Mixing System has not been fixed to the oscillation arm correctly or at
all. The mixing process will continue once the UNGUATOR
The programmed mixing time will be completed at the set speed step with steady up
and down movement of the UNGUATOR
parameters can also be changed during the mixing process using the same procedure
for initial programming of the mixing process.
Freespin can be done when mixing time is complete, and is indicated by "FSP" on the
display. The oscillation arm moves downward till the mixing blade hits the
®
UNGUATOR Jar Lid, then the mixing motor is accelerated to speed step "9". The
®
UNGUATOR MB now cleans itself via high-speed rotation close to the lid, a process
referred to as freespin motion. Almost all ointment is removed from the UNGUATOR
and mixing is complete. The display now indicates total mixing time including reset
times.
28
Speed
720 rpm
900 rpm
1080 rpm
1260 rpm
1440 rpm
MB shaft of the prepared UNGUATOR
®
The mixing process using the UNGUATOR
Step
5 1630 rpm
6 1810 rpm
7 1990 rpm
8 2160 rpm
9 2340 rpm
®
Mixing System is run upward
Mixing System has been screwed tightly into
®
®
Mixing System. The mixing time and speed
Speed
®
MB will then
is detected by the sensor.
®
Jar
®
MB
®
e/s