INSTALLATION
WARNING
The installation technician shall operate in full
compliance with all the applicable technical standards
in order to grant the unit safety.
TO INSTALL THE DEVICE, PERFORM THE
FOLLOWING OPERATIONS:
Remove the central screw and the plastic door.
1
Remove the two screws shown in the drawing then
2
remove the whole body from the base.
ASSEM LY IT CA LE INPUT ON T E REAR PANEL:
3
if the cable fasteners (delivered with the unit) are not
re uired for installation use a screwdriver to remove
the base bloc s permitting the cables to pass through
and t the bloc s delivered (see point ).
4