manages and controls the operation of the
installation according to the programmed
data.
- MANUAL:
the collector pump is continuously powered;
the only active controls will be those related
to the maximum temperature and safety.
- A C:
this mode is identical to the Manual mode
except that the collector pump will be
activated only when the temperature of the
collector exceeds ' T A C ' programmed in
the relevant installer parameter.
RESET
In order to reset the device press the key labelled as
' RESET ' located behind the removable door; DO NOT USE
PINS OR NEEDLES.
INSTALLER PARAMETERS
To access the installer parameters press the '
Entering the Password
The display will show 'PWD 0000' with the leftmost digit
ashing thus requesting for the correct password.
In order to set the 4 password digits use the '
key; by pressing the '
' key the current digit is con rmed
and the ashing is transferred to the following digit.
After con rming the last digit the '
to the installer parameters.
The initial password is factory set as '0000'.
Modifying the Password
In order to modify the stored password rst press the '
key then proceed as follows:
T E ISPLAY S O S ' P
ENTER T E CURRENT PASS OR .
(same procedure described above)
' key.
T E ISPLAY S O S ' P
' or '
'
1
' key will give access
PRESS T E ' MENU ' KEY.
N
'
'.
'.