Hysteresis Of The Safety Temperatures; Thermostatic Hysteresis; Probe Offset; Maximum Temperature Of The Probes - Ariston ELIOS 25 Manual

Hysteresis it is rst necessary to increase the value of
the Differential ( T).

Hysteresis of the safety temperatures

Data Regulation range
YTS 1. .. 15. C

Thermostatic hysteresis

Data Regulation range
YT 1. .. 15. C

Probe Offset

Data Regulation range
OS1 -5. .. +5. C
OS2 -5. .. +5. C
OS3 -5. .. +5. C
OS4 -5. .. +5. C

Maximum temperature of the probes

Data Regulation range
TM2 2 . ..
TM3 2 . ..
TM4 2 . ..
Default
2. C
Default
2. C
Default
. C
. C
. C
. C
Default
. C . C
. C . C
. C . C
2
WARNING!
It is not possible to set the Maximum Temperature (TM)
to a value higher than the relevant Safety Temperature,
as the Maximum Temperature value is limited to the
value of the Safety Temperature (TS) -5°C. To increase
the Maximum Temperature value, it is rst necessary to
increase the value of the Safety Temperature.
Integration Temperature (After Heating) on probe S3
Data Regulation range
TA 4 . .. (TM3 -5) C
WARNING!
It is not possible to set the value of the integration
temperature (TAH) at a value which is higher than the
Maximum Temperature (TM3) because the value of the
integration temperature (TAH) is linked to the Maximum
Temperature (TM3) -5°C.
In order to lower the value of the Maximum Temperature
(TM3) below the value of the integration temperature
Default
45. C