Float Switch Replacement - Henny Penny AHC-993 Technical Manual

3-15. FLOAT SWITCH
REPLACEMENT
Figure 3-1
Figure 3-2
Figure 3-3
Figure 3-4
Figure 3-5
Feb. 2011
To avoid electrical shock or property damage, move the
POWER switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
1. While wearing heat resistant gloves or using a grasping
tool, remove overflow tube and allow water to drain from
pan. Figure 3-1.
Hot water! Do not touch the overflow tube or place
your hand in the water in the water pan when draining
the unit. Failure to follow this warning could result in
severe burns and injury.
2. Remove screws and lower access panel from rear of unit.
Figure 3-2.
3. Unplug wires to float switch. Figure 3-3.
4. Remove nut securing the float switch and pull float switch
from unit. Figure 3-4.
5. Install new float switch in reverse order, making sure float
switch is in upright position. Figure 3-5.
6. Unit is now ready for use.
3-14
Model AHC-990/993