Setting A Hard Disk Drive Master And User Password In System Setup - Toshiba S100-S1133 User Manual

S100-s1133 user's guide
Hide thumbs Also See for S100-S1133:
Table of Contents

Advertisement

178
Toshiba Utilities
Hard disk drive passwords
message appears. Repeat steps 5 and 6 to enter the
password again.
7
If you want to delete the user password, leave the space
blank and press
Registered
8
Press
9
When System Setup prompts you to confirm your
change, Press
Setting a hard disk drive master and user password in
System Setup
To register master and user passwords in System Setup:
1
Click Start, then click Shutdown, and click OK.
The computer shuts down.
2
Hold down the
button until the on/off light on the system indicator panel
illuminates (green) for approximately one second. When
the following message appears on the screen: "Check
system, Then press [F1] key," press
The System Setup screen appears.
3
Press
screen.
4
Press the spacebar to select Master + User password
mode.
Enter
.
to save the change.
End
.
Y
Make sure you choose a hard disk drive master password you
can remember easily. If you set a hard disk drive user
password and later forget the password or lose your password
diskette, you will need to enter the hard disk drive master
password in order to access your hard disk.
Esc
to move to the HDD PASSWORD section on the
H
twice. System Setup displays:
key and press and hold the power
.
F1
Not

Advertisement

Table of Contents
loading

This manual is also suitable for:

S100-s113tdS100-s213tdS100-s1132Portege s100 series

Table of Contents