Setup Instructions; How To Mount The Options - Toro MH-400 Operator's Manual

Setup Instructions

An authorized Toro distributor normally sets up the MH-
400 Material Delivery Unit at the time of purchase. See
the Setup Manual for more information.
If you purchased the electric brakes, your authorized
Toro distributor will install these too.
This section covers how to install the Twin Spinner and
cross conveyor options onto the MH-400. When lifting
the options, use the option caddy if possible (see page
34).

How to Mount the Options

Every MH-400 comes equipped with a pair of "quick-
attach" universal mounting brackets located at the rear.
Use these brackets to mount options to the MH-400.
No tools are required to install or remove the options.
: Ensure that the tow vehicle
W
ARNING
is turned off before installing an option.
1. Connect the MH-400 to the tow-vehicle. See
Operating Instructions – Connecting the MH-400 to
the tow vehicle.
2. Remove the safety latch clips from the clamp
handles.
3. Lift the safety latch, then lift the option attachment
clamp handles, and release the lock rings from the
lock pins (Figure 7).
Setup Instructions
4. Slide the rear option attachment clamp assembly out
of the quick-attach slots and into the brackets.
5. Insert the front edge of the option up and under the
rear of the MH-400 into the front clamps on the
brackets.
6. Support the option in place, then slide the rear option
attachment clamp assembly back into the slots in the
brackets, and over the rear.
7. Ensure that the option is centered between the
brackets. Then re-install the lock rings over the lock
pins and push down on the clamp handles.
Note – If the clamp assembly is too loose and the option
slides within the clamps, turn the lock rings into the
clamps a few turns until the option is secure.
: Do not over-tighten the clamps. This
I
MPORTANT
may bend the edges of the option.
: Ensure that you re-install the
C
AUTION
safety latch clips into the clamps.
Otherwise, the clamps may open during
operation.
: The options are heavy. Use
W
ARNING
the option caddy to lift the options.
Wear gloves to protect your hands.
Page 17